G2 (A+B) Clear Vision
Two-component, invisible coating that strengthens all kinds of glass surfaces.
Creates a hydrophobic, sustainable layer that channels the water with minimal use of car wipers.
Lowers the amount of dirt that settles on the car, it has anti-reflective properties, reduces amounts of scratches and mechanical damage.
- glass surfaces in mechanical vehicles (windows, mirrors, headlights, sunroofs)
Method of use
- Do not use the product in temperature below 10ºC!
- Do not expose the surface to sunlight.
- Make sure that the surface is not hot.
- Provide proper ventilation and fresh air.
- If the surface was strengthened by different water-proof products, you will need to remove them beforehand.
Step 1: Mixing.
Mix two ingredients at room temperature in 1:1 ratio for about 3 minutes.
After that, mixture is ready to use for 1 day.
Before applying, the surface must be cleaned out and room temperature must be between 10ºC and 30ºC (15-25ºC is the most optimal).
Once the mixture is mixed, you don’t need to mix it again before applying.
Step 2: Cleaning the surface.
Stability of the applied coating and its resistance to scratching, depends on how product will be chemically bounded with the surface.
That’s why it is extremely important to clean the surface before applying G2.
Clean it with standard product for cleaning glass and wipe it until it is dry.
Step 3: Applying G2 product.
Avoid direct exposure to sunlight.
When applying the product to car windows, both sides of it should be strengthened one after the other. Apply prepared product (according to step 1) in the form of the thin film and quickly polish it with paper towel for 30-60 seconds.
Do not let the product dry off on its own.
Before drying, excess substance must be collected with clean paper towel.
Stains and product’s remains must be fully polished with clean paper towel.
Hydrophobic effect is usually seen after 5-15 minutes (depending on the ground, reactivity and temperature) and it’s enhanced after a few minutes, but it is recommended to leave the surface with applied film for about 30 minutes.
In case of car windows, do not use the wipers for that time.
Step 4: Rebuilding the surface that has been coated with G2 before.
Film may be applied again according to steps 1-3.
If glass surface was strengthened with other hydrophobic products, you will need to remove them, before applying G2.
025 - 0,025l